Following the same process as the primer, cut in the walls with your chosen paint. For best results, paint one wall at a time. This makes it easier to spread the paint while it’s still wet. Work from top to bottom, rolling the paint in V or W-shaped strokes. Before applying a second coat, wait two to four hours. Then proceed with the same process used for the first coat. Denver Home Painting
Paper/poly drop cloths: $2 to $6 for 9x12-feet. The best of both paper and plastic, these cloths are low-cost and disposable. They absorb paint drips while providing more protection for what's underneath. They also provide some protection from slipping. Plus, you can cut paper/poly drop cloths to fit the space. But, like paper, paper/poly drop cloths can rip more easily than plastic or canvas drop cloths. Home Painters Denver CO
While vinyl siding salespeople claim it never needs to be painted, it does lose its color strength over time, and the degree of fading can vary depending on which sides get the most exposure to sunlight. Perhaps it still hasn’t faded, but you don’t like the color much. You can’t go any darker than its current color, though, because the siding is designed to absorb only so much heat, and a darker color could cause it to buckle. Vinyl paint is available in many colors. Brush painting and roll painting vinyl siding costs $43 per 100 sq. ft., and spray painting costs $34 per 100 sq. ft. Denver House Painting
Prime. Dark colors, stains (once sealed), and previously unpainted surfaces (drywall, spackle, etc.) will need a primer coat, usually white. NOTE: most paint stores & home improvement centers will now tint primer (at no charge) to match fairly close to the color of the finished coat, that way two coats of primer need not be applied. Although not all surfaces need a prime coat, skip this step at your peril! Dark colors will likely show through the first -- or even the first couple-- topcoats of paint. Sealants and unpainted surfaces like spackle patches will absorb or repel moisture in a topcoat at a different level than the areas surrounding them. Applying a good primer coat will help even out these differences. Primer equalizes a wall to a uniform surface. It's like erasing a canvas before drawing a new picture. Although some will argue the point, you generally don't need to spend a great deal on primer or buy special primer. A cheap, 5 gallon (18.9 L) bucket of plain, flat white paint will usually do the trick and cover a large area. Give your primer at least 24 hours to dry (follow its instructions) before applying a topcoat. Denver Home Painting
If there is any peeling — and there usually is somewhere — it's essential to scrape off any loose paint. This doesn't just mean the parts that are already separated from the wood and ready to fall off on their own. Each spot where paint has peeled loose needs to be scraped thoroughly until you can no longer get the sharp corner of a putty knife under any of the surrounding edges of paint. Then, the bare spot needs to be sanded until the paint edges are smooth.
Prep work should include removing all loose paint, either with a pressure washer or by scraping; removing any trace of mildew using bleach and water or a commercial solution, and sealing or covering dark stains; caulking all seams, corners and around windows or trim; applying epoxy filler to repair serious woodwork problems; covering dark stains; sanding all rough surfaces, and priming the bare wood with a bonding primer. House Painting Denver Colorado